Dehumidifiers Error Codes

Indicates an alarm condition with dangerous concentrations of CO detected.

The unit is in an error condition and may be malfunctioning.

Shows that CO alarm had previously detected concentrations of 100ppm or greater.

Shows battery backup is operating during a power outage or low batteries.

Indicates very low batteries or unit malfunction. The CO alarm is not functioning.

Indicates tamper resist feature is activated and alarm has been unplugged.

Indicates the unit is in an error condition.

Indicates low battery warning.

Indicates the end of unit life.

Indicates an error condition detected by the unit.

Humidity sensor error — the humidity sensor is not functioning properly.

Unit malfunction — a general internal unit error has occurred.

Bucket removed or misplaced — the water collection bucket is not properly installed.

Refrigerant leakage detection malfunction — refrigerant leakage has been detected (on some models).

Temperature sensor error — the temperature sensor is not functioning properly.

Pump failure — the pump is not operating correctly.

Temperature sensor error.

Humidity sensor error.

Abnormal Coil sensor temperature or current.

Error code indicating system needs to be reset or service centre visit.

Water tank full or not properly inserted.

Signal that the water collection tank has reached capacity or may not be correctly seated.

Humidity sensor error.

General unit malfunction or error.

Temperature sensor error.

Bucket is full — dehumidifier will not operate until bucket is removed and emptied.

Bucket is full or bucket not in correct position.

Water tank is full.

Ambient temperature is too high or too low.

Ambient humidity is too high or too low.

Water tank is full or incorrectly positioned — the dehumidifier cannot continue operation until the tank is emptied or properly seated.

Malfunction error — indicates a general unit malfunction that requires troubleshooting.