Security Systems Error Codes

An intrusion has been detected and the system is armed, or a fire alarm or audible emergency alarm has occurred.

Exit error alarm was silenced by disarming before entry delay ended, preventing message to Central Monitoring Station.

System has been armed in one of the armed modes.

Low battery condition in a wireless sensor or low system battery.

External sounder wiring failure detected.

One or more burglary protection zones have been bypassed.

An alarm has been silenced by the security code plus OFF sequence and will remain displayed until another code plus OFF sequence is entered.

A malfunction has been discovered in the system, an open is detected in a fire zone, or a fault in a DAY/NIGHT burglary zone during a disarmed period.

External sounder wiring failure detected.

Telephone line (Telco) fault detected.

The chime feature is activated and will alert you to the opening of protected doors and windows while the system is disarmed.

General system trouble — indicates a non-specific fault or malfunction in the security system.

Loss of AC power — the system has lost its primary AC power source.

Low battery — the backup battery voltage is below acceptable operating levels.

System tamper — the control panel enclosure has been opened or tampered with.

Zone fault — one or more zones in the system is faulted and preventing normal operation.

An entry/exit door or interior zone remained faulted after exit delay expired, or a faulted zone was detected within two minutes after exit delay ended.

A fire alarm has been generated, either automatically by smoke/heat detectors or manually activated.

Low battery condition in a wireless transmitter.

Burglary alarm or audible emergency alarm has been triggered.

Fire alarm or carbon monoxide alarm condition.

Message waiting in voice keypad message center.

Voice keypad is in record mode.

AC power has been cut off and the system is operating on backup battery power.

The burglary portion of the system is not ready for arming due to open protection zones.

System is in test mode, low battery is detected at a transmitter, or system will autoarm within 10 minutes.

System has been disarmed, an arming attempt was made with an open zone, or bypass verification has been completed.

A trouble condition exists, memory of alarm is present, system low battery detected, external sounder wiring failure, or last 10 seconds of exit delay is active.

System is ready to be armed with no faults present.

Exit delay warning is active (if programmed) or entry delay warning is active, indicating time to exit or disarm the system.

System backup battery is low.

System has been armed in STAY, NIGHT-STAY, or INSTANT mode, or a zone opened while the system is in chime mode.

No keypad display and READY indicator is not lit, indicating complete loss of operating power from AC and backup battery.

System has been armed in AWAY or MAXIMUM mode.