Valberg W180C Washing Machine

What should I do before using my W180C washing machine for the first time?

Before using the washing machine, you must remove the transport bolts, adjust the feet to ensure the machine is level, and connect the water supply inlet hose and drain hose. Check that all accessories and supplied parts are present and inspect the machine for any damage during unpacking.

How do I remove the transport bolts from my W180C?

Using a wrench, unscrew all transportation bolts approximately 30mm in the direction indicated by the arrow without fully unscrewing them, then push the bolts inward horizontally and loosen them, and finally pull out the bolts along with the rubber and plastic parts. After removal, install the supplied transportation bolt covers by inserting them into the holes and pressing until they click into place.

What is the maximum washing capacity and spin speed of the W180C?

The W180C has a washing capacity of 7kg and a maximum spin speed of 1200rpm. The machine is rated for 220-240V and has a heating power of 1500W.

How should I connect the water inlet hose?

The blue-marked inlet hose is for cold water only and should be hand-tightened onto the tap. Ensure there are no kinks in the hose, check the water-tightness of connections by turning the tap completely on, and verify the appliance is not connected to an un-pressurized water heater mixing tap.

What should I do if my washing machine is making excessive noise?

Ensure the machine is level and that all transport bolts have been removed. Check if the load is balanced and redistribute the laundry if necessary.

How do I properly level the W180C washing machine?

The appliance must be installed on a solid and level floor surface, and you should use a spirit level to check. If the floor is uneven, unscrew the locknut clockwise using a wrench, lift the machine slightly, adjust the height of the foot by rotating it, then tighten the locknut by turning it anti-clockwise towards the appliance casing.