Frigidaire FRSS2623AS Side-by-Side Refrigerator

What should I do if my refrigerator is not cooling properly?

First, ensure the refrigerator is plugged in and the power is on. Then check if the temperature settings are correctly adjusted and verify that the refrigerator doors are properly closed. If these steps don't resolve the issue, the refrigerator may require professional service.

How do I connect the water supply to my Frss2623As?

Disconnect the refrigerator from electrical power, then flush the water supply line until water runs clear. Remove the plastic cap from the water valve inlet, insert the supply line ¼ inch into the inlet, and tighten the compression nut by hand then an additional ½ turn with a wrench. Reconnect the refrigerator to power and turn on the water supply at the shutoff valve.

What water pressure is required for the ice maker and water dispenser?

The water supply must have a pressure between 30 and 100 psi for proper operation of the ice maker and water dispenser. If your water pressure is outside this range, you may experience reduced performance or malfunction.

How long does it take for the refrigerator to reach the desired temperature after setup?

You should allow 24 hours for the refrigerator to reach the set temperatures after installation. Do not adjust the temperature settings during this initial period.

What does error code E1 mean?

Error code E1 indicates that the freezer temperature is too high. This may mean the freezer compartment is not cooling to the desired temperature and should be investigated or serviced.

Why is my water dispenser not working?

First, confirm that the water supply is connected and turned on at the shutoff valve. If water still doesn't dispense, check if the water filter needs replacement, as a clogged filter can prevent water flow.