Roku GE Remote

What type and how many batteries does the Roku Ge Remote use?

The remote requires 2 x AA batteries. Insert them into the battery compartment on the back of the remote, paying attention to the + and – marks inside the compartment to ensure correct polarity.

How do I install batteries in the Roku Ge Remote?

Press down on the back of the remote and slide the battery cover to remove it. Insert 2 AA batteries, paying attention to the + and – marks inside the compartment. Re-align the cover, then slide it back into place until it clicks.

How do I program my remote using Direct Code Entry?

Turn on the device you want to control, then press and hold the SETUP button until the red light stays on and release it. Press and release the button corresponding to the device you want to control (TV, DVD, AUDIO, etc.), then enter the first 4-digit code listed in the manual. Point the remote at the device and test the buttons; if they don't work, repeat with the next code.

How do I use the Auto Code Search feature?

Manually turn on the device you want to control and hold the device button and ON/OFF button simultaneously until the red light stays on solid. Press and release the PLAY button, and the remote will send out a series of codes with a 5-second pause between each set. Press PLAY until the device turns off, then press REVERSE and wait 2 seconds to see if the device turns back on. If it does, press STOP to confirm the code.

What should I do if the remote doesn't operate my device?

Ensure the remote is pointed directly at your device with no obstructions between them, try the remote with the equipment powered ON and OFF, and make sure you use the correct device button to program the remote. Check if the red LED light blinks with each keypress (if not, replace the batteries), and note that your device may not be compatible with the remote if none of the codes work.

How do I reset the remote to factory settings?

Press and hold the SETUP button until the red light stays on, then release it. Press and release 0 (zero), then press and release ENTER. The red light will blink twice to confirm the factory reset is complete.